IVECO Daily

Brake lights come in two forms - the dashboard brake warning light, which indicates potential issues within the braking system, and brake tail lights that notify other drivers when you're decelerating or stopping.When your brake light comes on, your car is letting you know that either your vehicle is low on brake fluid, the emergency brake is activated, there's trouble within the ABS unit, or there's a problem with the sensors.

An exhaust valve is a valve that releases burned gases from a cylinder. The exhaust valve closes during the initial part of the induction stroke. The inlet valve usually opens a little before top dead center and the exhaust valve remains open a little after top dead center.Exhaust air flow control valves are screwed into the exhaust controls of control valves or drives. They enable the piston speed of cylinders or rotary drives to be controlled by restricting the air exhaust.

Cover plates are plates added to the flanges of beams to increase the flexural capacity of the beam over some portion of the beam. The use of cover plates in regions of high moment allows the use of a section of lesser weight and lesser flexural capacity to be used as the primary beam. a cover, hood, or head used to close in or cover over the end or top of a receptacle, chamber, or section of a structure

A bumper bracket is the part which keeps your bumper firmly on your car. You usually have more than one, and these metal pieces attach to the front and sides of your car's frame. Because the brackets are responsible for keeping your bumper where it belongs, it is important to replace them after an accident.

Your bumper acts as a shock absorber, and the cover is an added layer of protection. This helps protect valuable engine parts and expensive exterior pieces in the event of a collision. It can also help protect your exterior in more minor incidents like scrapes or from road debris.A lower bumper cover is a trim piece that forms part of the bumper. It attaches to the main bumper cover, and to the underbody of the car. Lower bumper covers are almost always made from a soft, flexible plastic. The lower bumper cover conceals the opening under the main bumper cover and between the front wheel wells.

Most modern cars do not have bumpers. The entire front of the car (fascia) is a flexible vinyl like material usually backed with a dense foam to provide support. The car can withstand a very minor impact. Usually no more than 5 mph. Any greater impact may mean the entire front fascia will need to be replaced.A bumper is a structure attached to or integrated with the front and rear ends of a motor vehicle, to absorb impact in a minor collision, ideally minimizing repair costs.

Spring clamps are commonly used to clamp wood, metal, plastic, and fabric with a single point of pressure. Their work is great for clamping stop blocks on fences or jigs, clamping power cords, fast and easy clamping, and gluing woodworking projects.Protect delicate surfaces: If you're clamping a delicate surface, place a piece of soft material, such as cloth or cardboard, between the clamp and the workpiece to prevent damage. Avoid over-tightening: Applying too much pressure can cause damage to your workpiece or even break the clamp.

A bumper bracket is the part which keeps your bumper firmly on your car. You usually have more than one, and these metal pieces attach to the front and sides of your car's frame. Because the brackets are responsible for keeping your bumper where it belongs, it is important to replace them after an accident.

a decorative feature on the side of a car. The success of the FE was equalled, if not exceeded, by the FC model with slightly brasher styling featuring chrome fins and side trim distinguishing it from the FE.Car mouldings include side body moulding, lower body moulding, door moldings, window mouldings, footrest moulding, mudflaps, etc. They are often found in services in association with car mats, etc.